[an error occurred while processing this directive]

Re: Chemicals into FW line


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]

Posted by D Ferrell on November 08, 2004 at 13:40:16:

In Reply to: Re: Chemicals into FW line posted by Kraig on September 25, 2004 at 14:21:17:

: We are going through the same scenario, our chemical supplier wants the sulfite going into the DA and the volamine and polytreat going into the FW for each boiler.: What problems could one expect, if they used a system that injects chemicals (caustic, phosphate, sludge) into the feed water line that is supplying 3 boilers that operate at 200PSI?

: : Most of the time 2 boilers are running, and the third is rotated in and out with the other two, so that at all times, at least to boilers are running. Load varies from 80 - 125Kpph.

: : There is much more to this, but I am curious as to what you all think.

: : Thanks,

: : ~Chuck

Chuck we had a leak develop at the point where the chemical was added in the feedwater line.Think the injector was too close to the pipe


Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]