[an error occurred while processing this directive]
Posted by Dee on October 01, 2004 at 10:04:33:
In Reply to: Re: Manual reset pressure control settings posted by Dee on October 01, 2004 at 09:54:55:
Thanks for the reply...There is no "Main" controller that I can see, just the Manual Reset Hi-limit controller and the Honeywell cut-in controller that I mentioned.
This new boiler and controls were just recently installed and we have only used it for Hot Water, so far. Not cold enough for heat, yet. They basically left us with this after "skimming" the system. It was set for around 10 psi, before I changed it.
From what you're saying, it will shut "off" when it reaches the new setting I made (1.5 psi) and I would have to re-set it?
It sounds like something wasn't installed and should have been?