[an error occurred while processing this directive]

Re: Sulphite Residual Test Procedure


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]

Posted by Dan on April 07, 2004 at 19:51:40:

In Reply to: Re: Sulphite Residual Test Procedure posted by Dan on April 07, 2004 at 19:50:25:

: : : I just have a quick question on testing for sulphite residuals in boiler water. I have two testing procedures and the chemicals to do the test are identical. However one test says to take the Number of drops of Potassium-Iodide-Iodate and multiply it by 2 to acheeve the end point and the other is multiplied by 10. Now I have never seen the X by 2 before until I started my new job. I can't find any reference to it at all. Just wondering if anyone out there can give me a little more information on this. Thanks Craig Butler

: :
: : What you need to do is find out the name of the manufacturer of the IO/IO and call them to find out the correct multiplier. If Taylor makes it and it is N126, the multiplier should be 10.

:
: Same for Nalco and Ge betz products. ML x 10 = PPM for 50ml sample




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]