[an error occurred while processing this directive]

Priority for my Amtrol indirect


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]

Posted by Denis on December 10, 2003 at 11:41:01:

I had a new furnace and Amtrol indirect hot water heater installed a little over a year ago. The setup is controlled by a TACO 6 zone controller with the zone 6 priority option.

The Amtrol is currently wired so that the heating zones can demand at the same time as the hot water which can be a bad combination if a couple of heating zones start demanding right when someone is taking a shower. Zone 6 is available so I would like to rewire the Amtrol to zone 6 but cannot find instructions or a diagram. I have the TACO diagram and am somewhat familiar with zone contollers but not with the indirect hot water heater wiring.

Has anyone out there done this?

Thanks...




Follow Ups:



Post a Followup

Name:
E-Mail:

Subject:

Comments:


[ Follow Ups ] [ Post Followup ] [ Boilerroom.com Steam-Forum - Number 3 ] [ FAQ ]