[an error occurred while processing this directive]
Posted by Ron Settimi on February 10, 2012 at 18:34:07:
Top hand needed for boiler company. Must be experienced in boiler fabrication, retubing, pipe fitting and welding. Must meet all of the following requirements:
Pass company's weld test
Be able to travel
Work in confined and elevated areas
Be self motivated and have leadership abilities
Boilermaker:
Assembles boilers, tanks, vats, and pressure vessels according to blueprint specifications, using power tools and handtools: Reads blueprint to determine location and relationship of parts. Connects firetubes to heads or watertubes to drums and headers of boilers, by expanding and belling ends, using tube expander and beading ends, using power hammer. Drills and taps holes for installation of studs, using portable drill. Tightens bolts to assemble frames, using hand or power wrenches. Mounts casings of watertube boilers, or attaches davit heads, burners, or furnace casing to firetube boilers, using wrenches. Bolts or screws accessories, such as manholes, handholes, fans, gauges, and valves to vessel, using handtools or power wrenches. Replaces defective parts, using power wrenches, prying bars, or handtools. May install and repair refractory brick. May thread and install stay bolts, using pipe wrench and dies. May remove and replace rivets and caulk seams to repair riveted shells and structures, using pneumatic chisel, riveter, and caulking hammer. May cut out defective parts, using acetylene torch.
Contact
HR Department at 214-637-0020