[an error occurred while processing this directive]
Posted by HeatPro on December 19, 2011 at 22:16:00:
In Reply to: reduction of flue pipe @ chimney posted by eddieb on December 17, 2011 at 20:30:13:
The fully informative question would be:
Is there a standard transmission fitting for a round flue of [unknown because you didn't state it's size] to a 6.5" x 10" chimney entrance.
However, a transition can be made up by a sheetmetal shop for a 7" round flue to fit the 6.4" x 10" hole as that is the 7" equivalent size round to feed that size hole without reductions.