[an error occurred while processing this directive]
Posted by mike on September 21, 2009 at 19:52:40:
In Reply to: Re: HONEYWELL BP900 Backflow Preventer posted by HeatPro on September 19, 2009 at 23:32:21:
: In most areas, adding a backflow preventer is involved with the local water supply. If this is about a well system, then that isn't involved.
: Operationally, the backflow overcomes at least 40 psig, so vertical wouldn't be a pressure difference problem; but I'd call Honeywell to find out, as the drawings for the device show it only in the horizontal position.
: http://www.alpinehomeair.com/_viewresource.cfm?resourceID=1096
:
: "Vertical installation of backflow preventers will be accepted if the device is approved by the State for that type of configuration. ..."
: http://www.westchestergov.com/health/Forms/PublicWaterSupply/Request_to_Install_Backflow_Device.pdf
: http://www.socalabpa.org/InstallationCriteria.pdf
I called Honeywell and they were useless after it took forever to get through.
Comfort calc.com forum, states I dont need it for a low pressure steam system. I dont know. I may just install vertical and see what happens unless there are some other suggestions? Any new hlp is appreciated