[an error occurred while processing this directive]
Posted by HeatPro on August 29, 2008 at 10:26:43:
In Reply to: Re: Leaking solder joints at boiler posted by Dan on August 29, 2008 at 10:14:23:
Where would you typically need expansion areas in the circuit, and what would you use?
+++ Solder to thread elbows at expansion swing joint points; not directly into the run, but a zig and zag so the threads can take the movement instead of the solder stress.
http://www.answers.com/topic/swing-joint
Do we really need glycol? We live in southern New England.
+++ Only when the heater doesn't work in the coldest weather below freezing. It is also a good reason to inspect and make sure you don't have leaks.