[an error occurred while processing this directive]
Posted by Tory on August 31, 2006 at 03:31:52:
Being new to radiant heat, I tried to bleed air from the water inlet by using a wrench on the Spirovent. Result, I'm replacing the Spirotop part.
The info from the company says that I can use strap wrenches to take off the top and put the new Spirotop on. I have used strap wrenches and, then, pipe wrenches but the top will not come loose.
Is it really made so that the top can be replaced?
Also, I was thinking of heating it up with a torch to loosen it, but didn't know if this would hurt anything inside. It is supposed to have an "O" ring in it.
Any suggestions?
Thanx