[an error occurred while processing this directive]
Posted by joe on May 19, 2006 at 16:37:18:
In Reply to: Re: Gas Steam Boiler posted by HeatPro on May 19, 2006 at 11:10:15:
Thank you. 1/2" it is. I'm almost ready for installation now that you've explained so much. Again, your advice is really appreciated. This forum is very lucky to have the best of the best on it.
I came across a hot water radiator today with a "Danfloss" valve at the supply. It looked like a balancing valve and it had a label marked "made in Denmark". Since I am handy but have no experience with hot water systems, would that be a balancing valve. Should I install one like that right onto the supply at the radiator, or just use a taco balancing valve (I won't use a simple ball valve).