[an error occurred while processing this directive]
Posted by Dave Mundee on November 13, 2005 at 16:01:41:
In Reply to: Re: Peerless heat exchanger pins posted by Joe Brix on November 12, 2005 at 08:40:04:
: Are you sure this not the result of going to hard on a flue brush between the pins? Might have knocked a few off.
Yes, I'm sure. They were in the chamber before I brushed. I swing the hinged burner door out before I brush and run a vac to draw most of the dust downward and away from me. The brush isn't tight and it brushed easily. I would think you'd rally have to jam it to break off a cast iron pin 1/4" diameter.