[an error occurred while processing this directive]
Posted by george on January 11, 2004 at 03:52:44:
I have a Axeman steam furnace in my 1860's farm
home. A honeywell 2"x7" aquastat, Beckett AF oil
burner. Lately I have been noticing that the motor
does not shut off cleanly, but goes out, then on
again for a few cycles before it finally cycles off.
Is this an electrical (bad relay contacts) or other?
It seens to start and run fine for most of the cycle
but only when shutting down has the intermittent problem.
Thanks for any help...
George