[an error occurred while processing this directive]
Posted by matt on March 10, 2005 at 08:38:42:
In Reply to: Power Vent Runs Needlessly posted by Doug Proulx on December 19, 2003 at 06:36:45:
: Hi.
: New system, Smith Cast Iron, Beckett Burner, taco control system, Honeywell Aquastat, etc. 4 zones.
: No chimney, so a power vent was employed.
: Any time any zone calls for heat, the power vent runs. This is even if the boiler does not need to run, just the circulator. I am worried because the power vent seems to run almost continuously, and if the boiler is not running, it is just pulling warm air from the basement.
: Any ideas? A different aquastat? A different controller on the Beckett? A different Taco? Or is this how it's supposed to be?
: Thanks.
Either you are miss pre and post purge controls on the power vent. Or it is wired wrong. Or the puge relay in defective