[an error occurred while processing this directive]
Posted by Ralph Blaine on November 05, 2004 at 19:55:31:
In Reply to: Re: adding air vents posted by HeatPro on November 05, 2004 at 17:50:48:
: The casting is a bit thin there. If you can clean the surface well and put fiberglass re-enforced epoxy about 1/4-inch thick on a dime-sized surface, then drill through the strengthened surface, it would have less possibility of cracking and give a material to tap the 1/8-inch pipe thread.
Thanks, I'll give it a try.