[an error occurred while processing this directive]
Posted by Shadowz on August 18, 2004 at 08:12:35:
I went around yesterday removing all my radiator bleeder values because I would like to replace them. I want to take them all with me to make sure I get the right sizes. On one of the radiators the valve broke as I was trying to remove it, there is enough sticking out that I can still grab it with something. But everything I tried so far has been stripping away from the metal and not turning it out. I tried a heat gun on it this morning to see if that would loosen it a bit. I may have to drill it out. What other ideas should I try before I give up.